STARGOLD 16” SIZE AND VOLTAGE 220-240V~ AND 3 SPEEDS FULL COPPER MOTOR POWER 60W ORBIT FAN MODEL SG-4052

ISTRUCTIONS FOR ASSEMBLY

1) Loosen the safety screw from the fan for removing the chassis

2) Making sure that the skie marked "UP" of the chassis faces the celling, attach if to the needed position with the two screws provided. (Fig.1)

3) Mount the fan by positioning the tab of the chassis into left side of the slot opening in the fan stand, and then turn the fan counter-clockwise until both tabs of chassis and fan base, place the safety screw tightly through the two tabs. (Fig 283)

4) Connect the lead wires from the fan base to the power supply, make sure black wire to live, white wire to natural and yellow-green wire to grounding of supply.

5) Loosen grill mounting nut from the motor housing.

6) Position rear grill firmly to motor housing and then fasten by tuming grill mounting nut clockwise tightly.

7) Push the blade along motor shaft, fasten if firmly with spinner by turning counter-clockwise.

8) Assembly the grill ornament to front grill with screws provided.

9) Adjust the front grill to back grill with firming the clips and safety screw.

10) Ensure that the distance from the ground to the fan blades exceeds 2.3 meters during installation.

INSTALLTION OF THE REGULATOR

1. Make sure the switch of regulator is at off position.

2. Remove the regulator cover by loosening the screw on the front cover.

3. Connect lead wire from motor and supply to the appropriate tabs o the switch.

4. Place back the regulator cover.

NOTE: MOUNTING ON A HOLLOW WALL MAY CAUSE VIBRATION.

MAINTENANCE

Store the fan in a dry and cool place

Always keep the unit clean from dust. Use a piece of soft cloth damped with water and soap to clean the dust and stains. Do not use any kind of solvents which can damage the unit.

Once the unit clean, store it in a dry and cool place

WARNING

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

PRECAUTIONS

1. Do not plug the power cord into the outlet until the unit has been completely assembled.

2. Before connecting the plug, make sure the voltage of the unit and the outlet are the same.

3. Do not insert your fingers inside the grill or guard while the fan is working.

4. Do not attempt to force the louver to turn.